Введение
DROPS 204-7
suncatchersmittens
DROPS design: Pattern x-439
Yarn group C
SIZE: S/M
Measurements: Circumference: approx. 21 cm. Length: approx. 24 cm.
MATERIALS
DROPS ALASKA from Garnstudio (belongs to yarn group C)
50 g colour 02, off white
100 g colour 58, mustard
Materials & Sizes
KNITTING TENSION
19 stitches in width and 25 rows vertically with pattern = 10 x 10 cm.
NEEDLES
DROPS DOUBLE POINTED NEEDLES SIZE 4 mm: for stocking stitch with Nordic pattern.
DROPS DOUBLE POINTED NEEDLES SIZE 3.5 mm for rib
Needle size is only a suggestion! If you have too many stitches on 10 cm switch to larger needles. If you have too few stitches on 10 cm switch to smaller needles.
You might also like...
Women Accessories Gloves & Mittens Easter Workshop Mittens Nordic Gloves & Mittenscolourwork nordic
Pattern instructions
Keep the screen on while knitting
Tools
PATTERN
See diagrams A.1 to A.5.
MITTENS - SHORT OVERVIEW OF THE PIECE
Worked in the round on double pointed needles.
RIGHT MITTEN
Cast on 36 stitches on double pointed needles size 3.5 mm and work rib in the round with knit 2/purl 2 with colour pattern as shown in diagram A.1. After diagram A.1 switch to double pointed needles size 4 mm and work the rest of piece in stocking stitch. Work according to diagram A.2 and increase 4 stitches evenly on 1st round = 40 stitches. When it has been worked up to the grey squares in the diagram, work A.3 over these stitches = thumb. REMEMBER THE KNITTING TENSION!
When diagram A.3 has been worked, 8 stitches have been increased in A.3 (= 11 stitches in A.3). On next round insert A.3 on a stitch holder and cast on 3 new stitches (cast on stitches as show above the 3 grey stitches in A.2). When A.2 has been worked, cut the strands before pulling them through the remaining stitches. Tighten tog and fasten.
THUMB
Insert the 11 stitches from stitch holder back in double pointed needle size 4 mm, knit in addition up 9 stitches at the back (and in the sides towards the 11 stitches) of thumb, where 3 stitches were cast on. To make this look nice knit up stitches while increasing stitches as follows: Begin by working A.4 over stitches on needle. Then knit up 1 stitch with mustard, 1 yarn over with off white, knit up 1 stitch with off white, 1 yarn over with off white, knit up 1 stitch with mustard, 1 yarn over with off white, knit up 1 stitch with off white, 1 yarn over with off white and knit up 1 stitch with mustard. Now first round in A.4 has been knitted. On next round knit yarn overs from previous round twisted according to pattern in 2nd round of A.4. When A.4 has been worked, cut the strands before pulling them through the remaining stitches. Tighten tog and fasten.
LEFT MITTEN
Work the same way as right mitten but work according to diagram A.5 instead of A.2.
I.e. work as follows: Cast on 36 stitches and work A.1 the same way as right mitten. Then work diagram A.5 while increasing 4 stitches on 1st round, work A.3 as on right mitten but in the opposite side (where the grey squares are drawn into A.5). When A.5 has been worked, knit the thumb the same way as on right thumb.
This pattern has been corrected. Click here to see the correction/s.
Diagram
= off white
= mustard
= decrease 1 stitch towards the left as follows: Slip next stitch knitwise, knit 1 with mustard and pass slipped stitch over stitch worked.
= decrease 1 stitch towards the right as follows: Knit 2 together with mustard.
= decrease 3 stitches together into 1 as follows: Slip 1 stitch knitwise, knit 2 stitches together with mustard, pass slipped stitch over stitches worked together.
= work thumb gusset here, i.e. A.3
= between 2 stitches make 1 yarn over with mustard
