Введение
DROPS 225-6
sidewalkartisthat
DROPS Design: Pattern no ai-362
Yarn group C or A + A
SIZES
SIZES
S/M - M/L - L/XL
Fits head size: 54/56 - 56/58 - 58/60 cm
MATERIALS
DROPS AIR from Garnstudio (belongs to yarn group C)
50-100-100 g colour 02, wheat
Materials & Sizes
NEEDLES
DROPS CIRCULAR NEEDLE SIZE 4.5 MM: Length 40 cm for stocking stitch.
DROPS CIRCULAR NEEDLE SIZE 4 MM: Length 40 cm for rib.
DROPS DOUBLE POINTED NEEDLES SIZE 4.5 MM.
The technique MAGIC LOOP can be used – you then only need circular needle of 80 cm in each size.
KNITTING TENSION
18 stitches in width and 23 rows in height with stocking stitch = 10 x 10 cm.
NOTE: Needle size is only a guide. If you get too many stitches on 10 cm, change to a larger needle size. If you get too few stitches on 10 cm, change to a smaller needle size.
You might also like...
Women Accessories Hats Berets Gift Ideasstocking stitch
Pattern instructions
Keep the screen on while knitting
Tools
INCREASE TIP
Work to the marker, make 1 yarn over (= 1 stitch increased), marker here. On the next round knit the yarn over twisted to avoid a hole. Repeat at each marker.
DECREASE TIP
Work until there are 2 stitches left before the marker, knit 2 together (= 1 stitch decreased). Repeat at each marker.
SHAPING TIP
Wet the beret and carefully press out any excess water. Lay the beret flat over a plate with approx. the same diameter, then place the plate on a glass so the beret is not touching the surface. Leave to dry then remove the plate carefully. Repeat after each wash.
BERET – SHORT OVERVIEW OF THE PIECE
The piece is worked in the round with circular needle, bottom up. Change to double pointed needles when necessary.
BERET
Cast on 92-96-100 stitches with circular needle size 4 mm and DROPS Air. Knit 1 round. Then work rib in the round (knit 2, purl 2) for 2 cm. Change to circular needle size 4.5 mm. Knit 1 round where the number of stitches is adjusted to 91-98-105 stitches. Continue with stocking stitch. On the first round insert 7 markers as follows: Insert 1 marker at the beginning of the round, work 13-14-15 stitches, * insert 1 marker, work 13-14-15 stitches , repeat from -* to the end of the round. Allow the markers to follow your work onwards; they are used when increasing and decreasing.
On the next round increase 1 stitch before each marker – read INCREASE TIP (= 7 stitches increased). Increase like this every 4th round a total of 4 times = 119-126-133 stitches.
REMEMBER THE KNITTING TENSION!
Continue working until the piece measures 12-13-14 cm.
On the next round decrease 1 stitch before each marker – read DECREASE TIP (= 7 stitches decreased). Decrease like this every 2nd round a total of 15-16-17 times = 14 stitches left.
Knit all stitches together 2 and 2 = 7 stitches. Cut the strand, pull it through the remaining stitches, tighten and fasten well. The beret measures approx. 25-27-28 cm – read SHAPING TIP.
