Введение
DROPS 203-17
decemberdunesshawl
DROPS design: Pattern la-041
Yarn group A
SIZE
Height: Measured along the middle = approx. 39 cm
Width: Measured along the top side from side to side = approx. 162 cm.
MATERIALS
DROPS ALPACA from Garnstudio (belongs to yarn group A)
250 g colour 2020, light nougat
or use:
DROPS LACE from Garnstudio (belongs to yarn group A)
100 g colour 2020, light camel
Materials & Sizes
KNITTING TENSION
23 stitches in width and 45 rows vertically in garter stitch = 10 x 10 cm.
NEEDLES
DROPS CIRCULAR NEEDLE SIZE 3.5 mm: Length 80 cm.
Needle size is only a suggestion! If you have too many stitches on 10 cm switch to larger needles. If you have too few stitches on 10 cm switch to smaller needles.
You might also like...
Women Accessories Big Shawls Shawlslace wave pattern
Pattern instructions
Keep the screen on while knitting
Tools
EXPLANATION FOR THE PATTERN
GARTER STITCH (back and forth):
Knit all rows. 2 rows = 1 ridge.
EYELET ROW
When working eyelet row, increase at the beginning of the row as before.
Work as follows:
ROW 1: Make 1 yarn over, knit 1, 1 yarn over, knit 1. * knit 2 together, 1 yarn over , work from -* until 3 stitches remain, and knit 3.
ROW 2: Make 1 yarn over, knit 1, 1 yarn over, knit the rest of stitches.
INCREASE TIP-1 (evenly):
To calculate how to increase evenly, use the total number of stitches on row (e.g. 33 stitches) and divide stitches by number of increases to be done (e.g. 12) = 2.7.
In this example increase by making 1 yarn over after alternately every 2nd and 3rd stitch. On next row knit yarn overs twisted to avoid holes.
INCREASE TIP-2:
If the knitting tension is incorrect the shawl can have the wrong number of stitches if you need to work more or less rows than stated to get the correct measurements in cm. This error can be corrected on next increase ridge. If you work to tightly, so that e.g. 6 cm is not 15 ridges as in pattern, but e.g. 16 ridges, there will be 4 or 2 stitches to many on needle (depending on it being before or after INCREASE RIDGE 3). If you work to loose, there will be too few stitches on needle when worked to given measurements in cm. This can be adjusted on next increase ridge, so that number of stitches is the same as number of stitches given when increase ridge is done.
PATTERN
See diagram A.1. Diagrams show all rows in pattern seen from the right side.
SHAPING
Place the piece in lukewarm water until it is soaking wet. Carefully squeeze out the water - do not twist. Then roll the piece in a towel and squeeze to remove more water. The piece will now only be moist. Place the piece on a carpet or mattress - carefully stretch it out to measurements found under SIZE at the top of pattern and leave to dry. Repeat the process when the piece has been washed.
SHAWL - SHORT OVERVIEW OF THE PIECE
Worked back and forth on circular needle to make room for all the stitches. Most of the shawl is worked in GARTER STITCH - read explanation above, work the edge at the bottom in wave pattern.
SHAWL
Cast on 13 stitches on circular needle size 3.5 mm with Lace. Knit 1 row from wrong side.
Continue as follows:
ROW 1 (= right side): Make 1 yarn over, knit 1, 1 yarn over, knit the rest of stitches (= 2 stitches increased).
ROW 2 (= wrong side): Make 1 yarn over, knit 1, 1 yarn over, knit the rest of stitches (= 2 stitches increased).
Work in garter stitch and continue to increase 2 stitches at the beginning of every row until 4 ridges have been worked in total from beginning (= 4 stitches increased per ridge) = 29 stitches.
Work 1 EYELET ROW - read explanation above (= 4 stitches increased) = 33 stitches.
REMEMBER THE KNITTING TENSION!
INCREASE RIDGE 1:
Knit 1 row from right side while increasing 12 stitches evenly - read INCREASE TIP-1 in explanation over. Knit next row, knit yarn overs twisted = 45 stitches.
Work in garter stitch and continue to increase 2 stitches at the beginning of every row as before until 3 ridges have been worked in total (including increase ridge) from previous eyelet row (= 4 stitches increased per ridge) = 53 stitches.
Work 1 EYELET ROW. Work in garter stitch and continue to increase 2 stitches at the beginning of every row as before until 3 ridges have been worked after eyelet row , work from - 2 times in total (= 4 stitches increased per ridge/eyelet row) = 85 stitches.
Work 1 EYELET ROW (= 4 stitches increased) = 89 stitches.
INCREASE RIDGE 2:
Knit 1 row from right side while increasing 21 stitches evenly. Knit next row, knit yarn overs twisted = 110 stitches.
Work in garter stitch and continue to increase 2 stitches at the beginning of every row as before until piece measures 6 cm from previous eyelet row, equals approx. 15 ridges (including previous increase ridge) (= 4 stitches increased per ridge) = 166 stitches. If the number of stitches deviates, adjust on next increase ridge - READ INCREASE TIP-2 in explanation above.
INCREASE RIDGE 3:
Knit 1 row from right side while increasing 57 stitches evenly. There should now be 223 stitches on needle. Knit next row, knit yarn overs twisted.
NOTE: Now the increase in the side will change from 2 stitches to 1 stitch (on eyelet rows also increase only 1 stitch in the side on each row) - increase and work as follows:
ROW 1 (= right side): Knit 1, 1 yarn over and knit the rest of the stitches (= 1 stitch increased).
ROW 2 (= wrong side): Knit 1, 1 yarn over and knit the rest of the stitches (= 1 stitch increased).
Work in garter stitch and increase in the sides this way until 3 ridges in total have been worked from previous increase ridge (= 2 stitches increased per ridge) = 229 stitches.
Work 1 EYELET ROW - read explanation above. Work in garter stitch and continue to increase 1 stitch at the beginning of every row as before until 2 ridges have been worked in total after eyelet row , work from - 4 times in total (2 stitches increased per ridge/eyelet row) = 253 stitches.
Work 1 EYELET ROW (= 2 stitches increased) = 255 stitches.
Work in garter stitch and continue to increase 1 stitch at the beginning of every row as before until piece measures 3 cm from previous eyelet row, equals approx. 7 ridges (= 2 stitches increased per ridge) = 269 stitches. If the number of stitches deviates along the way, adjust on next increase ridge - read INCREASE TIP-2.
Work 1 EYELET ROW (= 2 stitches increased) = 271 stitches.
INCREASE RIDGE 4:
Knit 1 row from right side while increasing 64 stitches evenly. There should now be 335 stitches on needle. Knit next row, knit yarn overs twisted.
Work in garter stitch and continue to increase 1 stitch at the beginning of every row as before until piece measures 3 cm from previous eyelet row, equals approx. 7 ridges (2 stitches increased per ridge) = 349 stitches. Piece measures approx. 25 cm measured on the middle from cast-on edge and down. Now it is important to have the correct number of stitches because of the diagrams. If you need to, you can work 1 more ridge and adjust the number of stitches if the number is incorrect.
Work according to diagram A.1 as follows: Work 2 edge stitches in garter stitch, work A.1 (= 15 stitches) until 2 stitches remain on needle (repeat A.1 23 times) and work 2 edge stitches in garter stitch. Work diagram 1 time vertically.
CAST-OFF
To avoid a tight cast-off, make yarn overs when casting off by knitting from right side as follows: Make 1 yarn over over the stitches that were yarn overs in pattern, cast off yarn overs as stitches. Make sure to avoid tightening the yarn along the way. If the edge still is tight use a larger needle size for cast-off. Cut and fasten the yarn. When shawl is done, wash and shape if you want - read SHAPING in explanation above.
This pattern has been corrected. Click here to see the correction/s.
Diagram
= knit from the right side, purl from the wrong side
= knit from wrong side
= slip 1 stitch, knit 1 and pass slipped stitch over stitch worked
= knit 2 together
= between 2 stitches make 1 yarn over, knit yarn over twisted on next row. It should not make a hole.
= arrow shows how many stitches there are in every repetition on this row in diagram
= between 2 stitches make 1 yarn over, knit yarn over on next row. It should make hole.
