Введение
DROPS 211-3
autumnwillowsshawl
DROPS Design: Pattern no as-123
Yarn group C or A + A
SIZE
The piece measures approx.: Width = 55 cm. Length = 150 cm.
MATERIALS
DROPS BRUSHED ALPACA SILK from Garnstudio (belongs to yarn group C)
150 g colour 22, pale rust
Materials & Sizes
KNITTING TENSION
17 stitches in width and 22 rows in height with stocking stitch = 10 x 10 cm.
NEEDLES
DROPS CIRCULAR NEEDLE SIZE 5 MM: Length 60 cm or 80 cm for stocking stitch and pattern.
DROPS CIRCULAR NEEDLE SIZE 4.5 MM: Length 60 cm or 80 cm for rib.
Needle size is only a guide. If you get too many stitches on 10 cm, change to a larger needle size. If you get too few stitches on 10 cm, change to a smaller needle size.
You might also like...
Women Accessories Scarves Shawlslace leaf pattern
Pattern instructions
Keep the screen on while knitting
Tools
EXPLANATIONS FOR THE PATTERN
RIDGE/GARTER STITCH (worked back and forth):
Knit all rows.
1 ridge in height = Knit 2 rows.
PATTERN
See diagrams A.1 to A.4 (A.1 and A.2 for the rib). The diagrams show all the rows in the pattern seen from the right side.
CASTING-OFF TIP
To avoid the cast-off edge being tight you can cast off with a larger size needle. If the edge is still tight, make 1 yarn over after approx. each 4th stitch at the same time as casting off and the yarn overs are cast off as normal stitches.
STOLE – SHORT OVERVIEW OF THE PIECE
The piece is worked back and forth in 2 parts, bottom up as far as the middle. The parts are then sewn together.
STOLE – PART 1:
Cast on, a little loosely, 129 stitches with circular needle size 4.5 mm and Brushed Alpaca Silk.
Purl 1 row (= wrong side). The next row is worked as follows from the right side: Work 3 edge stitches in GARTER STITCH – read description above, work A.1 over the next 102 stitches (= 3 repeats of 34 stitches), A.2 (= 21 stitches) and finish with 3 edge stitches in garter stitch. Continue this rib and decrease as shown in the diagrams.
When A.1 and A.2 have been completed there are 94 stitches on the needle and the piece measures approx. 5 cm in height.
Change to circular needle size 5 mm and work the next row as follows from the right side: Work 3 edge stitches in garter stitch, A.3 over the next 75 stitches (= 3 repeats of 25 stitches), work A.4 (= 13 stitches) and finish with 3 edge stitches in garter stitch.
Continue this pattern back and forth. REMEMBER THE KNITTING TENSION!
When the piece measures approx. 74 cm change to circular needle size 4.5 mm.
Knit 1 row from the wrong side, knit 1 row from the right side and knit 1 row from the wrong side. Read CASTING-OFF TIP and cast off with knit from the right side. The piece measures approx. 75 cm.
PART 2:
Work in the same way as part 1.
ASSEMBLY
Sew parts 1 and 2 together in the middle – sew in the outermost loop of the outermost stitch so the seam is flat and make sure the seam is not tight.
Diagram
= knit from right side, purl from wrong side
= purl from right side, knit from wrong side
= between 2 stitches make 2 yarn overs; on the next row purl the one yarn over and drop the other (= 1 stitch increased and leaves a hole)
= slip 1 stitch as if to knit, knit 2 together and pass the slipped stitch over the knitted stitch (= 2 stitches decreased)
= knit 3 together (= 2 stitches decreased)
= knit 3, pass the first stitch worked (of these 3) over the other 2 so it lies around them (= 1 stitch decreased)
= knit 2 together
= this square has no stitch because it was decreased earlier; go straight to the next symbol in the diagram
